-
Sales
-
Lifting
-
Plumbers
- Pressing
- Wet/Dry Vacs
-
Pipe Fabrication
-
Wrenches
- RapidGrip® Wrenches
- Grip Wrenches
- 2-Handle Wrenches
- Specific Purpose Wrenches
- Straight Pipe Wrenches
- End Pipe Wrenches
- Offset Pipe Wrenches
- Hex Wrenches
- Chain Wrenches
- Strap Wrenches
- Compound Leverage Wrenches
- Raprench® Wrench
- Spud Wrench
- Inner Tube Core Barrel Wrenches
- Adjustable Wrenches
- Chain Tongs
- Wrench (Various)
- Pipe Cutting & Fabrication
- Roll Grooving
- Threading
- Tube Repair & Joining
- Tube Cutting & Preparation
- Bending & Forming
- Pipe Bevelling
- Large diameter pipe tools
- Plastic Pipes
- Pipes Various Tools
- Threading Oil
-
Wrenches
- Plumber's tools
-
Hydraulic
-
Electrical
-
Utility & Electricians Tools
- Knockout Sets
- Conduit Benders
- Sizing Tools
- RE 60 Electrical Tool
- RE 6 Cable Termination Tool
- LR-60B Latching Round Crimp Head
- SC-60C Scissor Cutter Head
- Manual Hydraulic Crimp Tools
- Swiv-L-Punch™ Knockout Punch Head
- 4P-6 4PIN™ Dieless Crimp Head
- Cable Trimmers
- UC-60 Utility Crimp Head
- RE 600 Cable Termination Tools
- Test & Measurement
-
Utility & Electricians Tools
-
Lifting
- Rental
- Repair and certification
- About us
- Contact us
K-1500G Machine Only with A-1 RIDGID Drain Cleaning Mitt, A-12 Coupling Pin Key and A-34-10 Rear Guide Hose, A-369-X 1¼" (32 mm
44587
2" to 10" (50 to 250 mm) Drain/Sewer LinesA gasoline engine makes the Model K-1500G well-suited for cleaning lines in remote locations where electrical power is unavailable. Cuts through roots fast.Unique, easy-to-use, instant-acting cable clutch maximizes operator control.Pull down on the...
2" to 10" (50 to 250 mm) Drain/Sewer Lines
- A gasoline engine makes the Model K-1500G well-suited for cleaning lines in remote locations where electrical power is unavailable. Cuts through roots fast.
- Unique, easy-to-use, instant-acting cable clutch maximizes operator control.Pull down on the handle and the cable spins at 600 RPM.Release handle, cable stops instantly.
- Comes equipped to use 1 1?4" (32 mm) cable to clean 3" (75 mm) to 10" (250 mm) lines through 300' (92 m).
- 6 HP gasoline engine drives cable via four-speed transmission. Allows the operator to vary the cable spinning speed to fit the application. Forward speeds of 333, 425 and 500 RPM, and a reverse speed of 250 RPM.
- Low-profile, four-wheel cart easily rolls to the job. Guards against machine upset and possible fuel spillage.
- Includes A-1 RIDGID® drain cleaning mitt and operator’s manual.
44587
Data sheet
- Width Wheel to Wheel
- 26" (66 cm).
- Length Including Kickstand
- 28" (71 cm).
- Ground to Top of Handle
- 38" (97 cm).
- Type of product
- UNITES_SPECIALE_R